Serving Wayne, NJ & Passaic CountyOpen 24/7 · (973) 488-5410
Home / Plumbing Services / Faucet & Sink Repair

Faucet & Sink Repair in Wayne, NJ

A dripping faucet, low pressure at one fixture, or water pooling under the sink all point to a specific, fixable cause. We diagnose and repair faucets and sinks across Wayne, with an upfront price before any work starts.

24/7 dispatchSame-day serviceUpfront pricing
Wayne dispatch
(973) 488-5410
Call Now
Signs Something's Wrong

Common Faucet & Sink Problems

  • ✓
    A persistent drip even when the faucet is fully shut off.
  • ✓
    Low water pressure at one specific fixture, not the whole house.
  • ✓
    Water pooling under the sink, often a supply line or P-trap issue rather than the faucet itself.
  • ✓
    A loose or wobbly faucet base, usually worn mounting hardware underneath the sink deck.
  • ✓
    A slow-draining sink that a plunger doesn't fully clear.
Faucet Types

Why the Fix Depends on the Faucet Type

A dripping compression faucet, common in older Wayne homes, usually needs a simple washer replacement. Newer cartridge, ball, or ceramic disc faucets fail differently, and using the wrong repair approach on the wrong mechanism often makes the leak worse rather than better. That's why we identify the actual faucet type before quoting a fix, rather than assuming every drip has the same cause.

Kitchen faucets with a pull-down sprayer add another common failure point: the internal hose and its diverter valve wear out independently of the main faucet body, which is why a kitchen faucet can develop a new leak or lose spray function even after the main valve was already replaced once.

Bathroom sink faucets tend to fail differently, more often from mineral buildup inside the aerator or valve restricting flow than from an outright leak, which is why a sudden drop in pressure at just one sink is worth checking before assuming it's a bigger plumbing issue. According to plumbing code standards followed across New Jersey, supply line and shutoff valve work should isolate each fixture independently, which is what makes an under-sink repair possible without shutting off water to the whole house.

Dripping Faucet or Pooling Water?

Most repairs are same-day.

☎ Call Now
What We Check

How We Diagnose a Faucet or Sink Issue

Faucet Internals

Washers, O-rings, and cartridges wear differently by faucet type, and we match the fix to the actual mechanism.

Supply Lines

A failing flexible supply line connection is a common, easy-to-miss cause of under-sink pooling.

P-Trap & Drain Assembly

A worn seal or crack here mimics a faucet leak but needs a different fix entirely.

Water Pressure

Low pressure at one fixture only usually points to a clogged aerator or a partially closed shutoff valve, not a house-wide issue.

Pricing

What Affects the Price

Every faucet or sink job gets a flat, written price before work starts.
Repair vs. ReplaceA cartridge or washer swap costs noticeably less than a full faucet replacement job.
Faucet TypePull-down kitchen faucets and specialty fixtures sometimes need brand-specific replacement parts.
Under-Sink ScopeSupply line or P-trap replacement is priced separately from the faucet repair itself.
Customer-Supplied FixtureInstalling a faucet you've already purchased costs less than sourcing one for you.

A note on under-sink leaks specifically: a flexible braided supply line has a limited service life, typically 8-10 years, and replacing an aging one proactively during another repair is often worth doing rather than waiting for it to fail at an inconvenient time.

Want your real number? Call (973) 488-5410 and describe exactly what you're noticing and which fixture is affected, including how long it's been happening.

Around Wayne

Kitchen and Bath Repairs Across Wayne

Whether the home is in a lake community like Pines Lake or elsewhere in Wayne, faucet and sink calls often come down to worn cartridges, corroded shutoffs, or supply lines that were never replaced during a remodel.

Valves and Supply Lines

Shutoff Valves, Supply Lines, and Leaks Behind the Cabinet

Many leaks that look like faucet trouble start at a valve. Shutoff valves sit under sinks, behind toilets, behind washing machines, and on outdoor walls. They move rarely, so they seize, corrode, and start dripping at the stem. A valve that has not turned in ten years may refuse to close when you need it.

Never force a stuck valve. A handle that snaps can turn a drip into a flood. Close the main shutoff instead, then call. Replacing a worn valve takes a short visit, and the water can come back on right after.

  • ✓
    Under a sink: a drip at the stem or the compression nut means the valve or supply line is aging.
  • ✓
    Behind a washing machine: a wet wall or a damp floor often points to a worn valve or a cracked hose.
  • ✓
    Outdoors: a spigot that drips after being shut off may have a failed washer or stem.
  • ✓
    Anywhere: a valve that cannot be closed fully is worth replacing before a small leak grows.

If water is flowing and will not stop, use our burst pipe repair page for the first steps.

Showers and Tubs

Shower Valve, Showerhead, and Tub Faucet Problems

A handle that drips after you turn it off

The cartridge inside the valve has worn. Replacing the cartridge usually ends the drip without opening the wall, though the exact part depends on the valve brand and model.

Water that swings between hot and cold

A pressure balancing cartridge may be failing, or the water heater may be struggling. If other taps hold steady, the shower valve is the likely cause.

A tub spout that leaks while the shower runs

The diverter is not sealing fully, so water escapes through the spout. A new diverter or spout often solves it. Stains on a ceiling or wall near the shower deserve a closer look, and our leak detection page covers hidden leaks.

FAQs

Common Questions

A persistent drip usually means a worn washer, O-ring, or cartridge inside the faucet, depending on the faucet type. It's a straightforward repair in most cases.

That's usually a failing supply line connection, a worn P-trap seal, or a crack in the drain assembly, not the faucet itself. We check the whole under-sink assembly, not just the visible drip.

Yes, we can source and install a specific brand or finish, or work with a faucet you've already purchased.

A slow drip adds up on your water bill over time and often gets worse rather than better, so it's worth addressing before it becomes a bigger repair.

Do not force it, since a snapped handle makes the problem larger. Close the main shutoff to stop the water and call us. We replace worn valves so each fixture can be shut off on its own again.

Yes. We replace worn washing machine valves and cracked supply hoses as part of fixture repair. Tell dispatch whether the valve is a single lever or a two-handle type so the right part is on the truck.

A worn cartridge is the usual cause. The part has to match the valve brand and model, so describe the handle style or send the model details when you call. Most replacements are completed in one visit.

If the body is sound and parts are available, repair is usually cheaper. If parts are hard to find, or the finish is failing and leaks keep returning, replacement may cost less over time. We explain both and you choose.

Most repairs are finished in a single visit when parts are on hand. Older or specialty fixtures may need a part ordered, and the technician tells you before leaving.

Related Services

Often Needed Together

Dripping Faucet or Pooling Water?

Most repairs are completed same-day.

☎ Call (973) 488-5410
Need a plumber now?☎ Call Now